I installed an 8-pin plug DCC conversion harness and a Digitrax decoder in my new Walthers Milwaukee SW-1 HO switch engine. The engine is now running fine, however I’m not happy with the way I had to fold the wiring harness in order to install the decoder in an open space atop the PC board. I’m now either looking for a shorter DCC harness or cutting and re-soldering the harness wires. Likely a lot of work for a small return. Do they make a shorter harness?
![](https://i0.wp.com/www.pacificcascaderailway.com/wp-content/uploads/2018/10/2018-10-07-Milw-engine-3.jpg?fit=624%2C468)
DCC conversion complete?
Leave a reply